-
Why are u selling it?
-
If it works so well why would sell it since it has such a huge build volume? Any pics of prints that came from the machine?
-
I finally got my FFCP running. So after doing a couple of test prints from the SD card, I ended up with jammed filament in both of the extruders. Cheap generic PLA filament going in the trash. It clogged my Duplicator i3 as well no matter what temp I used. Anyway, after removing the fans from both …
-
Do you know of any US suppliers that may would have that in stock instead of ordering overseas?
-
I probably didn’t get my point across well and shouldn’t have said anything at all LOL because the OP needed an out of the box solution, not a kit… again, not putting down the MK2 at all… it’s a pretty awesome printer. I was just pointing to the comment that the MK2 was one of the best printers avai…
-
I have a FFCP that has what appears to be a bad controller board. One of the end-stops will not work and I’ve swapped the actually end-stop and the cable and it still doesn’t work. The LED will not turn on when the switch is pressed. So I guess it’s a problem with the control board itself. I haven’…
-
The XY design is more stable than the i3, usually. But regarding the MK2 i3, the only advantage buying directly from Prusa at that price is it’s already built. It’s 3D printed parts along with off-the-shelf parts. The design is excellent. But it’s an open-sourced printer that anyone can download, pr…
-
I have a Wanhao Duplicator i3 that is making a clicking noise at the extruder. Most prints look very good even with this clicking… or it’s rather a thumping sound I guess. I have replaced the brass gear with one with more teeth for better extrusion. But I had this thumping noise before the new gear…
-
The Z endstop does work. X and Y does not. The led’s light up when the endstop is pressed but movement does not stop. I tested using job mode as well. If it were just one axis not working I would think a bad cable, but not 2 at once.
