-
Thanks for the heads up. I wouldn’t have seen this without your post.
If you’re using the same gcode files on multiple printers and the printers are acting differently, I’d verify that you’re running the same firmware and settings on the printers themselves.
-
Good to know about the charring temp on the PTFE. I haven’t yet had any jams at 250C - but I could probably get away with less. The brand of ABS I’ve been using was having major layer adhesion issues with anything less than 245 or so, so I hopped up to 250. Perhaps it’s time for me to find a new bra…
-
I print ABS on an FF Creator Pro almost exclusively. I don’t have any issues with warping after the following techniques were employed. I print at 250C for most things, w/ 110C bed Glass bed w/ Kapton tape ABS+Acetone Slurry Taped/Closed Carry Handles while printing, don’t open the door, use the r…
-
I will definitely do this! Thanks much. (Watch, now it will never happen again…
-
Wait wait wait… you mean this isn’t the forum for Portland Maine? *crawls back to Beaverton*
-
Did you figure out why the bed did not stop lifting once the switch was depressed?
-
+1 to simplify 3d
-
What sort of material do you want to print? The enclosed printing area on the FlashForge will make printing ABS more successful. Not to say that you can’t print ABS on the Printrbot, but it’s more suited for PLA.