-
The raspberry pi isn’t really a mod. It’s more like setting up a separate computer. Here is the link to repetier server http://www.repetier-server.com/ They have a separate build for the Rapsberry Pi. Its the armel version. Here is the video playlist I used to upgrade to the E3d v6 https://www.y…
-
I wish I had saved the walk through I used. It wasn’t a video I just googled “davinci duo repeteir firmware” or something like that. Sorry I can’t be more specific. The short version of it was you short out a jumper on the board in the back (J23 I think) to wipe the firmware. I got the Repetier .92…
-
I just learned that mine is a 2.0 not a 2.0a thanks to another thread. Mine is not blue so it’s a 2.0. I found this out immediately after I replied to your comment in the other thread. Sorry about the confusion. edit: turns out the comment I learned about the blue-grey thing from is you also. haha.…
-
well that’s simple. Mine is grey, well more white than grey. definitely not blue though.
-
I use .92. I don’t think I have a 2.0a but I forget. I bought it a little more than a year ago. I have 2 cooling fans
-
get some E3d v6s
-
Using just repetier you need to leave it connected. This is the one downside to repetier host, however you can easily get around this by using a raspberry pi running repetier server. You run repetier host on you computer like normal but instead of connection to your printer directly you connect to r…
-
I have flashed my duo so I don’t use the cartridges anymore. Before I did that though I bought something to reset the chips so that I could use other filament instead of buying theirs. It is much cheaper that way. HOWEVER, they changed XYZWare shortly after that to send all of your print jobs to the…
-
I’m not sure if I have a 2.0a or not but I have the dual cooling fans. I am running .92
-
Flash to reptier firmware and forget about XYZWare
-
Have you tired turning it off and back on again? Haha jk. When I flashed my firmware (probably a year ago) XYZPrinting ware getting rather tricky with XYZWare to make sure you did eveything the way they wanted it done (to make sure you bought their cartridges as you know) even to the point of bricki…
-
I’m doing a dual e3d v6 hotend swap on my Da Vinci Duo this weekend. I flashed it to use Repetier I don’t know how long a go but it is SOOOOOO much better than the XYZWare. Plus you don’t need to use their filament. I don’t know about J-Head but I know it has been done on the 1.0 with a E3D V6. Etha…
