-
Hi Itopher, I sometimes get this problem as well. Luckily, there is a solution to this problem! Firstly, if you try using plyers, then maybe you can force the filament out. Do not try too hard as you may damage your machine. The other solution is to watch this video here: da Vinci Jr. 1.0 - Drive …
-
Hey, I have pretty bad warping on by davinci jr. I understand that having a heated bed does help, but I cant upgrade. I use blue painters tape but I still get very bad warping. I just want to know if there is a way to mitigate the problems of warping.
-
Whenever I print, my extruder makes a really bad noise. It sounds like creaking wood. It is really annoying and I want to know if anyone has had this problem and fixed it. thanks!
-
Hi Makerdaan, Sorry if this was unclear, but what I mean by extruder is the motor which pushes the motor into the actual hotend. On the Davinci Jr. it is the spot which you first enter the filament into and the teflon tube is connected in. Thanks for the help!
-
Hey guys, I am really annoyed as I cannot print for more than three hours without a filament jam. Basically, after three hours of straight printing, the filament messes up in some way and I get a jam. Its very annoying because you waste filament and you waste time. It happened now and I am so fed up…
-
Hey, I am having a problem where my filament is slipping out of the extruder. It makes a loud thud and some of the filament slips out, but is pulled back in. It is not much of an issue since I still got a successful 9 hour print with the filament slipping. I just want to try to minimize my chances …
-
Hey guys, I have seen many people build ultimakers out of aluminium extrusions. I am planning on building one, any advice? I dont have the money for a 2+ so I think that building a clone is a great alternative. Thanks
-
I am pretty sure that you can buy a spool of filament with the chip, unravel the xyz pla then put on your own. Since the PLA will melt at the same temperature, it should still print equally. As long as it is the same diameter it should work. The xyz printer uses the chip to detect how much filament …
-
I have a DaVinci jr and I used to have a problem where the filament jammed in the extruder.l (the jr had a Bowden extruder.) I fixed it by running the auto calibration don’t know if this will help you
-
Hi, I have a davinci jr, I am wondering if I can flash the printer as well. I REALLY hate xyzware since it doesnt work. I can’t put anything on the build plate and the rotating doesnt work. Would it be the same process or not? Thanks,
-
I noticed that in the top right corner, there is an option to change what the printer does. So you can change it to scan or engrave stuff. Of course you need a compatible printer but I think its just that all the features of the different printers were brought into one program.
-
True
-
Hey, how long does this process take? I submitted my form on Friday.
