-
Also if not installed, you need this: http://www.ftdichip.com/FTDrivers.htm the driver makes iT possible to communicate with the arduino. hope iT helpt !
-
Try uploading the arduino blinking led sketch. If that uploads and works then you know it is not the connection.
-
What worked for me was: Small nozzle 0,25mm, warm up te Nylon filament in an oven about 30min @ 110°c. Printing very slow and cover the printer so the heat stays inside te printing chamber.Extruder temp 260-280°c. For adhesion on te bed i use 3Dlac and blue painters tape. Its like printing PLA, …
-
I have used it, the clear filaments are good but the colored filaments aren’t so good for the machine. Had a lot of clogged nozzles with it because they use to much color dye in the filament. The polymere itself is stronger then regular PLA. The ABS of ICE filament is very good. I had good result…
-
I had the same problem with the Olson block:-s. Drill the hole bigger, or polish the inside of the block that worked for me…
-
Comes with 5 x PLA 1.75mm and is brand new in the boxs. (color white) For price you can contact me on my.
-
nope
-
sorry my bad
-
The stl needs to be handled with discretion, so if you want i can send you the stl, and maybe you can print it in piece?
-
vergeten de eenheden bij te zetten, kan jij en print van 80cm doen ?
-
Can someone print me a print that is 80 CM X 30 CM X 30 CM with a lot of details?
-
I can print on my 3 Ultimaker’s! You can contact me on my Hub if you like!
