-
Good to have you back. 3D printing takes a lot of patience and skills. I also have a Wanhao i3 that I almost gave up on, wanted to sell it on FB groups. My issues were changing/feeding filaments with the stock extruder which made it easier after upgrading to Micro Swiss nozzle and heater block kit. …
-
Haven’t seen you switch out filaments? Have you tried a different brand? I think you should start with PLA and get a hang of the settings. i.e leveling, quality, etc then move to ABS. ABS needs hi-temp + optional ABS glue/slurry to get the first layer stick to the bed, PLA doesn’t 60 bed temp woul…
-
Are the BOM list hard to find?
-
That is huge and looking good. Looking forward for the £260 Guide and BOM.
-
How is the bed being supported with larger or heavier prints?
-
Try to level your bed again and add more distance between your nozzle and bed. I normally use 0.15mm to get a nice first layer. Yours like its way too close to the bed.
-
Yes, communication is the key! Before accepting an order, I take my time looking at the 3D model (overhangs, support, etc.) and take my time to do a test print. Then explain the scenario on how to get the job done and once customer agrees with the proposal, I accept the print job otherwise custome…
