-
Where might I find a replacement?
-
Didn’t work. Same thing happened again…
-
I just cleaned out every single part of the extruder, trying the print again, fingers crossed.
-
I’m using 230C with ABS.
-
Hello, I am having a major issue with my FlashForge Creator Pro that is causing me to no longer be able to use it. First off, I started a print and noticed that the filament was getting thinner and thicker, as in, at some points during the printing of the raft, it would get thin for a second, and t…
-
So I was recently having an extrusion problem with my printer, and I cleared out the extruder and it was working fine. It was extruding at a somewhat steady rate, and the print was looking good. I came back later and the print stopped midway through, and had started printing air. I was using Replica…
-
My temperature is already at 230, so how do I fix the wheel from slipping?
-
Now something far worse is happening, and this is something completely unrelated to the slicer. The extruder is not extruding the filament at a constant rate. When I try to load the extruder, barely any filament comes out, but when it does it is slow and not constant. Sometimes it will stop and then…
-
I’ll try FlashPrint.
-
Alright, I’ll try this. Thanks
-
Hi. I’ve recently been having an issue with my Flashforge Creator Pro. I am using Replicator G to process my STL’s to GCode, just in case that might be related. What is happening is the top few layers are now being printed completely, resulting in the middle part of the print exposed. There are so…
-
I have tried all of this, and nothing works. Can someone tell me simply how to adjust the tension?
-
No, I’m not hearing any clicking. I have used this width of filament before, and it has worked. I am able to push the filament through with my hand, so I know it’s not jammed. It might be, as you said, too thick or too thin. How might I test this? Or, resorting to my original question, how would I …
-
I am able to push the filament through with my hand, and it works fine. After that, it will work on it’s own and extrude about a quarter of a centimeter more, and then it will stop extruding on its own. And yes, it is hot to the touch. I am sure it’s heating up to the proper temperature. Also, just…
-
Recently, my FlashForge Creator Pro has stopped working. The head will move, as if it is printing, but no filament will come out. I have talked to a few people personally, and they told me to look at the filament after trying to print. I did, and saw that there was a scrape on the side, like an inde…
