-
Where might I find a replacement?
-
Didn’t work. Same thing happened again…
-
I just cleaned out every single part of the extruder, trying the print again, fingers crossed.
-
I’m using 230C with ABS.
-
My temperature is already at 230, so how do I fix the wheel from slipping?
-
Now something far worse is happening, and this is something completely unrelated to the slicer. The extruder is not extruding the filament at a constant rate. When I try to load the extruder, barely any filament comes out, but when it does it is slow and not constant. Sometimes it will stop and then…
-
I’ll try FlashPrint.
-
Alright, I’ll try this. Thanks
-
I have tried all of this, and nothing works. Can someone tell me simply how to adjust the tension?
-
No, I’m not hearing any clicking. I have used this width of filament before, and it has worked. I am able to push the filament through with my hand, so I know it’s not jammed. It might be, as you said, too thick or too thin. How might I test this? Or, resorting to my original question, how would I …
-
I am able to push the filament through with my hand, and it works fine. After that, it will work on it’s own and extrude about a quarter of a centimeter more, and then it will stop extruding on its own. And yes, it is hot to the touch. I am sure it’s heating up to the proper temperature. Also, just…
