cannot print gear set

3D Printers

May 22, '17

Sometimes support does not provide its task. Especially with a cylinder. I do it manually as an additional model from the cylinder of the contour of the model falling into the corner. [img_20150626_153630.jpg]

Makerbot Replicator 2 problems

3D Printers

Mar 18, '16

check wiring root stepper x

Problem with extrusion of PLA

3D Printers

Mar 18, '16

I think this solution does not solve the problem with unsticking permanently. Yes, a short pipe creates resistance. But plastic is melted. Why did he need so much force to come out of the nozzle? Looking at the picture, I see that it is simply not where to go, there is no gap between the bed and the…

Improving prints

3D Printers

Mar 10, '15

It because file stl, or obj have not 1 closed mash, it have more than 1. Slyser think it leaky between meshes. Boolean operation needed to unity all of the mesh, It’s mistake of model. Need check level of bed. Too close to nosel, that’s why first level too slim. [IMG_20150310_191550.jpg]