-
I want to add the BLTouch auto level to my A8 but I can’t find a really good description of the wiring. Antlabs shows where the wires should go but they also say to remove C45 but I cannot find that mentioned anywhere else. I was wondering if anyone could tell me why this is. I have also found a pin…
-
I replaced the Igus bearings with the original bearings that came with the printer, that helped a little, the bed runs very smooth in the y axis now with the belt disconnected. I replaced the idler pulley with a toothed pulley. The printer prints pretty good but if I print over 30mm speed the Y axis…
-
The belts were pretty tight, I loosened them up but still vibrates. I have the Igus bearings on the y axis I think I will try replacing them with the stock bearings tomorrow and see if that makes a difference. I have ordered a toothed idler pulley and a new stepper motor to see if that helps.
-
I checked the 4 bearings on the bed and they are still good the bed moves very smooth on the rails I’m wondering if the stepper motor might be bad as it sounds very loud now and with the belt connected and the steppers off the bed is very hard to move in the y axis
-
If you are comfortable using a soldering iron you can re solder the wires back just be sure to get the positives and negatives right
-
I have been printing with my printer now for about 5 months and I have been getting some nice prints, I did have a bad wire problem on the hot end fan and repaired that, however lately I have been getting a lot of vibration from the y axis. I have over 1000 hours on the unit now and the problem has …
-
have checked all the wiring and it checks out ok when i measure the voltage coming from the pins on the board I get power until the head starts printing then it shuts off and comes back on intermittantly while printing, I’ve done a few prints and they have come out fine but i’m concerned that the he…
-
I am new to 3d printing I have had my printer for about 3 months. Everything has been going very well with some very good results with my anet A8. However I recently noticed that the 20mm fan has been acting a little strange, It use to run continuously while printing now it turns on when I turn on t…
