-
Awesome, will do. Thank you!
-
Hey Tom, sounds good - I will definitely check it out. Thanks!
-
Just got it from the printrbot online store over black friday cuz of the 15% deal.
-
Hi ASquar3D, Appreciate your feedback. How did you go about diagnosing and fixing the issue?
-
Hi Flavio_Camus That was my initial guess as well. I’m not sure if this is significant but I can notice that the z axis acme screw wobbles a little at the top when it runs. The base of the screw where it meets the coupler is actually quite snug. I assumed that the top of the screw wobbling would be…
-
Hey Tom, Thanks for your reply. Do you have a picture of the clips securing the X and Y belt? Would love to see how it is done properly. The prints look really good! Hope I would get there soon.
-
Hey ianadan, This particular print used the Getting Started .ini file, which means the 0.1984mm layer height you mentioned. I will check on the belt tension - is there a good way to determine the right firmness? That’s probably the most frustrating part of my experience thus far - I got an assembl…
-
Awesome - thanks for the link!
-
Haha sounds like I will be spending a lot of time with my Printrbot Simple then. Cool, I’ll find an .stl to start that process. Will also move the Printrbot to a more stable surface.
-
Hey Jatmn, Thanks for your tips. I know that the comparison isn’t necessarily fair, but I’ve seen prints online from the same model that suggest that I should be getting better prints. The striations are pretty significant and unlike most of what I’ve seen come out of Printrbot in online reviews. W…
