-
Hello all; This morning my Anycubic Kossel linear plus began to heat up the extruder as soon as I turned on the power supply. I have the PSU 12v for heating up a heated bed I installed a few months ago. Everything has been working fine until this morning. What could be causing this uncontrolled he…
-
I have great success by first inserting the Micro SD card then plugging in the printer. Less than 1 minute later the printer auto homes and begins print.
-
Yeah good now…I was using a newer Arduino with the wrong firmware. The customer service got me on the right track. They were very helpful. Now I just have to make some time to start printing…
-
OK The issue that I am having is that the linear carriages go up to home (when i use G28) and then come back down about 95mm. my display reads x 0 y 0 z226.58… When I try to level the bed it always hits the print bed. How do I resolve this? I’m using Marlin firmware supplied and prontoface as recom…
-
That is Fantastic!
-
Cool…Thanks for that. I have been looking into it and the only downside is that they don’t offer a trial version LOL…I really like to support open source but too many folks are recommending it. I will be downloading it this weekend.
-
I have recently purchased one from Amazon(15 Apr) and have been printing almost daily. Lots of things on thingiverse to upgrade and very easy to level and use.
-
Hello all ! Has anyone used QIDI Tech and Simplify 3D software together? I’m thinking of purchasing but not sure if it is worth $150…
