Skip to main content
Skip to profile content
-
Looks bad but is anything bent or broken on the carriages? Did the carriage pop off the bearings on the left hand side? If everything looks okay try loosening the belt and lining everything up.
-
Your belt tight and aligned?
-
Swapped the thermocoupler 0 and 1 plugs on the mainboard, error followed. I’ll order a new one and see how it goes.
-
Perfect, thanks for the explanation. I’ll do some checking.
-
Which cable are we talking about, the one with the four prong end or the one to the thermocouple?
-
Anything else you have to do to get Cura set up?
-
Have you reset your offset and ran the print to calibrate? http://www.sailfishfirmware.com/doc/tuning-dual-extruder-calibration.html
