Inventure Status?

3D Printers

Feb 15, '16

Has anyone heard when they are to be shipping? I was told sometime in the middle of February.

Initial leveling

3D Printers

Feb 5, '16

So started up the FFCP and started the leveling sequence to prepare for printing a test file from the SD card. The leveling paper will not pass under the extruders at the center position even with the screw all of the way out. Has anyone else had this happen? Thanks, Jim

Fume Extraction

3D Printers

Jan 13, '16

I just purchased a FFCpro and realized that in our house, in winter, I have no where to really operate it in a safe manner. I don’t want to release any ultra-fine particles (UFP) in the house. Has anyone tried any of the fume extractors that seem to be available? I have seen 3DPrintClean and BOFA 3D…

Part Fell Off during FFCpro setup

3D Printers

Jan 7, '16

The part that fell off is .75" x .625" x .125", black, and has two slots in it. Where does it go? TIA, Jim [20160107_140735.jpg]