-
Hi, are you trying to print the stl file directly or the gcode generated by cura or another slicer?
-
The solder under the platform had weakened. I fixed it by returning it the whole unit to monoprice for a no-charge replacement. —jason
-
Although it seems unlikely, contamination on the mirrors could cause this problem. I bet this has happened to some folks, but the glass or tray underside are more accessible to smudges. I wonder if optical power loss is discernible when printing in clear resin.
-
Winson, has the problem been resolved?
-
I said it was strange, as though it was some rare fluke that only happened to you. Well it happened to me the day after your note. And i happened to see it. The arm snapped off the top portion of my print as it moved back from home. Trying to track when it happened (layer, percent complete, which sd…
-
This happened to me. The bed would heat intermittently, depending on where the bed was located, front or back. Only solution was to replace it. The wires appeared solidly soldered and nothing visibly wrong, but the connection was broken somewhere. I could make or break the circuit by wiggling the wi…
-
Wow that is strange. When it restarts, does it finish the second print or have you stopped it before finding out?
-
Kapton will get you to ~300 deg C which may be too close to your intended temperature (depends what material you are printing).
-
Are you able to press-while-turning to get out of that mode?
