-
Hi, there is a sensor to the right. it stops the printhead when it moves to the side. there is a switch on this sensor. check if a small led light on the sensor flashes up when you touch itbwoth your finger. if not than check if the plugs on the sensor are connected. maybe you have to open up the fi…
-
Flashprint creates that line automatically once you slice your model in Flashprint. As far as i know you cannot adjust settings for that first line of material in FlashPrint. The idea behind this line is to fill the Nozzle completely with Material so the actual Print of your object can start with a …
-
which flashforge printer is it?
-
Hi, this is a common problem especially in PLA printing without a heated Platform. Most common solution is to always use a glue stick on the platform before printing. Also make sure your bed is properly leveled! You can alos try using a Brim or a Raft. Both increase adhesion to the print bed. In …
-
Here is also a good video how to take the extruder apart:
-
I am not using Tinkercad, but maybe you could try some other 3D-Software like 123D Design from Autocad and see if it exports nicely from there into Flashprint and than slices it better. TinkerCAD has limitations i assume. It could also be an issue that is related to the size of the 3D Model (maybe t…
-
I don´t think it will be replaced soon. I am a Flashforge Distributor for Germany and haven´t heard of any major upgrades on the Flashforge Creator Pro 2016.
-
Get the Flashforge Creator Pro!
-
Hi Beamtech, hm that sounds like a funny problem. I would do exactly like you. Connect via USB and try updateing the firmware out of flashprint. Don´t know what to advice in this case just to maybe contact ff support. Maybe somebody else can help? Greetings!
-
never heard of this problem. I would probably try reinstalling the firmware or reset to factory settings.
-
Very good point, Perry_1, i think its good to mention the safety issue around 3d-printers. Actually even in the FF User-manual it is said not to leave printers unattended while they print. But on the other hand - who can manage to sit next to the printer for hours
-
It looks like that this is an electrical component that caught fire. All manufacturers of electronic devices have the challenge to make sure to always use original electronic components from their suppliers. The problem is that there are a lot of fake components around - especially in China this is …
-
Yes, i know that problem. Solved it by leveling the build plate at first. Must be done properly. Maybe try several times leveling and make some test prints. make sure first layer sticks properly. After that use a glue stick. that can also help.
