-
Thanks for the info. i use autodesk 123D and all the programmes that come with it! I use replicator to generate the Goode from the STL file that is created in 123D design
-
You need to replace the extruder heater coil.
-
Yea this happened a lot with the old slicers. Also I have an SD Card reader and it blinks when its writing a file. When it stops blinking it should be good to take out. But most of the times I reformat the SD card and then export and safety eject and then print. Should work like a charm.
-
Agreed. I’ve seen slicers say that a file was exported before they actually were. Also, “eject” your SD card via your OS before physically removing it from the computer.
-
I would Reformat the card and export the file again. When finally exported, double check the SD Card on your computer and make sure it is in there. If you see the file, I would safety eject the SD card. Then try printing. If it does this again let me know. Maybe try a different slicing program. I c…
