-
Scale the part down. Convert it from mm to inches or vice versa.
-
I would return it if its brand new.
-
I’m guessing you are using Makerbot desktop? I believe you can tune most things with that slicer. Simplify 3d makes it a bit easier though to tune the machine.
-
I would take of the nozzle. Make sure that the thermal barrier tube is clear. Make sure the nozzle if clear. If either of these two look to have anything in the way soak them in acetone over night and then use a can of air to try and clear them out. If this doesnt work I would replace your nozzle. A…
-
In simplify 3d you can add your own g-code to the end of prints. In the profile you are using open the edit screen. I think its in advanced > g-code > Ending script (or something like this). You will obviously have to write your own code for this. In the picture it seems like you found the correct…
-
It could be the heating block. If your heating block is not insulated well the heat will travel up. If the heat travels up that means the plastic in the motor gets a little mushy. If this happens your motor will usually just barely be able to push the filament and might make it come out stringy or n…
-
Where can I buy this in the US?
