-
Instructions are on the sd card. Power spec ultra uses flashforge dreamer profile in simplify3d. I recommend under the gcode tab in the profile settings to adjust the z-axis in 0.1 mm intervals. Negative intervals will bring the bed closer to the nozzle. Positive intervals the opposite. For PLA pr…
-
I would slow the speed down the 1st layer prints really slow so it squeezes the filament on the printbed so it will stick print from sd card if that printer lets you from what you explained about that printer I would return it if it goes back to Chinese
-
I forgot to say cura is totally free just download it from ultimaker.com software download
-
3D printing as I found out is not plug and play it has a huge learning curve I started with a prusa i3 printer then moved to ultimaker2. abs I found I needed to spray aqua net on buildplate to get it to stick on bed and max speed of 40mm but I been doing very good with abs which I prefer over pla I …
-
Have you tryed cura i have that and really like it its free, i have an ultimaker2 and am building a ultimaker2 extended version their are alot of information online forums on how to get started printing ,i did buy Simplify3D but like cura better try matterhackers their is info for printing in what e…
