-
What you guys think of it ? [ultimaker-3-3d-printer_0.jpg]
-
Hi everyone, I see alot of hubs nearby me (Antwerp) that offer invoices. I was wondering if you all have your hub registered as a business and pay taxes for it? Or how do you do it otherwise? Thanks in advance, Andreas
-
I’ve seen it too… I don’t know how to activate it.
-
Here a procedure a friend if mine from 3D Printing Academy in Hong Kong sent me: During our last workshop at CDNIS, we have developed a new, streamlined way to calibrate the Deltas without the need of the Autolevel Probe! It looks complicated but if performed carefully, it should not take much long…
-
Hi Hinloopen, a great question! I represent Fila-cycle.co.uk too and we have been active in this area for a good few years. It would be very interesting to find out. We currently use the existing waste streams, e.g. not from households but from the industries themselves. However we have experimented…
-
You need to set the current on the 8825 drivers. Use a jewellers metal screwdriver in the small adjustment screw slot. Connect a multimeter (set to volts) between the negative power supply (0V), and the screwdriver. Adjust the screw until it reads 0.5 volts. This will give a current of 1 amp, which…
![[ultimaker-3-3d-printer_0.jpg]](https://www.3dhubs.com/talk/uploads/db5060/original/2X/0/0d98109a66b9bd296f4b51d1bcabc63450a54fde.jpg){kind=link}