Settings for printing a Marvin on a Redback 2

[austweb]

3D Hubs Marvin - Key Chain

• ABS
• .200 Layer Height
• Machine Type: Redback2 Pictured
• 35% infill
• Heatbed at 70 Degree’s
• Hotends ran at 250 Degree’s
• No Raft
• No Supports
• Print Speed 3,000mm / min
  
  
  

[gabriela3d]

Looking good! What’s your overall experience with printing on a Redback? Cheers

[austweb]

It’s hard to keep jobs on the bed, but apart from that it builds very nicely.
The Hotends run a bit hotter than normal, 250 for PLA and 270 for ABS.

Bed maximum heat is only 95 degree’s, henceforth, ABS is a problem to keep down.

The dual bowdens work quite well and the feed system works very well.

[Nikki]

Nice one @ZUES and thanks for sharing settings. Look forward to seeing more prints from your Redback!