3D Hubs Marvin - Key Chain
- ABS
- .200 Layer Height
- Machine Type: Redback2 Pictured
- 35% infill
- Heatbed at 70 Degree’s
- Hotends ran at 250 Degree’s
- No Raft
- No Supports
- Print Speed 3,000mm / min
2 Likes
Looking good! What’s your overall experience with printing on a Redback? Cheers
It’s hard to keep jobs on the bed, but apart from that it builds very nicely.
The Hotends run a bit hotter than normal, 250 for PLA and 270 for ABS.
Bed maximum heat is only 95 degree’s, henceforth, ABS is a problem to keep down.
The dual bowdens work quite well and the feed system works very well.
2 Likes
Nikki
4
Nice one @ZUES and thanks for sharing settings. Look forward to seeing more prints from your Redback!
