Settings for printing a Marvin on a Redback 2

austweb · 2015-05-08T09:33:32.000Z

3D Hubs Marvin - Key Chain

ABS
.200 Layer Height
Machine Type: Redback2 Pictured
35% infill
Heatbed at 70 Degree’s
Hotends ran at 250 Degree’s
No Raft
No Supports
Print Speed 3,000mm / min

IMG_0566.JPG3024×4032 1.91 MB

IMG_0562.JPG2448×3264 1.51 MB

gabriela3d · 2015-05-09T16:10:44.000Z

Looking good! What’s your overall experience with printing on a Redback? Cheers

austweb · 2015-05-09T18:38:03.000Z

It’s hard to keep jobs on the bed, but apart from that it builds very nicely.
The Hotends run a bit hotter than normal, 250 for PLA and 270 for ABS.

Bed maximum heat is only 95 degree’s, henceforth, ABS is a problem to keep down.

The dual bowdens work quite well and the feed system works very well.

Nikki · 2015-05-10T12:47:31.000Z

Nice one @ZUES and thanks for sharing settings. Look forward to seeing more prints from your Redback!