Go to homepage
58 / 72
Jun 2016

Just Belgium,

Its weird, cause i would expect when i enter “B” the posibilities show up.

Hey, i’ve set up a test shipping option that listed Belgium for you. Can you check if it shows for you?

Hey, and what about any other country? Can you list those? Perhaps you could try using a different browser? I use Google Chrome. I also see the shipping I listed on your account. See attachment.

@Luuk

Actually, I can’t see your entry, Also I cannot list other countries and nether in a different browser. Tested chrome,firefox and internet explorer. Weird. I do not have special settings of anything I am aware of that can cause any troubles

8 days later
8 days later

Just from experience, Canada post wanted 9$ for a particular part and box to be shipped to the US but it was just before the potential strike so my usual postal lady advised I go elsewhere. I ended up shopping UPS who wanted 96$ for next day shipping, 87$ for two day and 68$ for three day. The cheapest I got was 32$ for seven day. Mind you this was a 200g part in a 12CMx12CMx12CM box. Shipping rates are all over the place anymore. A flat rate in my opinion is an awful idea.

A tip: I’ve read that padded envelopes are sometimes better to ship in than a small box, as they take less of a beating due to how they are handled.

Your box was on the larger end, but keep that in mind for the future.

Also: Purolator was a bit less than UPS, last I looked. Did you check them out?

No that day purolator was closed and they were my only option. Also, that box was by no means large, it literally fit in the palm of your hands. I can understand if the box was like a foot by a foot and weighed 10lbs that they would charge that much. But something as small as that was outrageously priced

The part was about 9cm tall, it was too much for a padded envelope. I’ve used them before for smaller prints, it’s a good alternative and depending on the part I normally won’t have to worry about it damaging as its naturally strong enough.