-
Thanks Jeff for your suggestions, much appreciated. PETG is a good suggestion for water resistance! Thank you, Thierry.
-
thank you so much for taking the time. I’ll check back with you once I have the proper size or I may try to use your drawing in Fusion 360… thanks a lot.
-
thank you so much to all of you for your feedback. I should be able to do some measurements with a calliper tomorrow evening Sydney time. Stay tuned!
-
There is the mixer mechanism in it. It’s a good idea but we would get into more trouble!!
-
Hi there, thanks for your feedback. Incorporating Jeff’s feedback, we could design a simple square piece that would be extending the existing part. I would have to do a junction between the 2 parts. I imagine I could tape the inside where the 2 parts join and seal it so no water is linking inside t…
-
Hi there, we need to recreate the 2 attached shower tapware parts. These parts need to be 25 to 30mm longer. I need some help to get me a 3D design for these parts so I can get them 3D printed in a water resistant material. Can anyone help me with this? I attached a couple of pictures to give you…
