-
I down loaded it a few weeks ago so it should be the latest
-
The firmware on the link is for v7. 2 the printer came with 7.8. I believe the manual said not to try and upgrade as it might cause issues. I have tried flash print but haven’t gotten the best results yet. I am also using octoprint with Slic3r and love it. No more moving the SD card back and forth a…
-
I have not rest the offset in the firmware. I assume it’s is correct as it works fine in all other slicers I’ve tried except Slic3r. I have down loaded Cura and might give it a try. The more I play the more I learn
-
I have played with flash print as well, I find it doesn’t do a very good job of printing g and have played with many settings to try and improve. The biggest issue I have with it is with when it move to start the next layer it doesn’t extrude for the first 2-5mm and just has a bit of filament come o…
-
Thanks so much I will give the additional G-code a try. I had tried the offset in Slic3r and it had no affect on the position. Thanks,
