Heated Bed Adhesive Removal

3D Printers

Jul 21, '16

It was a huge pain to remove. I basically just used my finger tips to “roll” it up little by little. I used some rubbing alcohol to wet it but not sure if that helped or made it worse. After I got a majority of the white paper like stuff off, cleaned the rest off of the sticky off with goo-gone. Att…

Maker Select v2 bed issues when it starts and ends

3D Printers

May 5, '16

Check that your Y axis stop (the switch on the back left corner) is being depressed by the bed (and that you removed the tape from it). If it is (you should be able to see and hear it clicking when the bed hits it), make sure the wires are connected. Or when homing Y, randomly click the switch with …