-
Joshua, Success!!! The lower layers are perfect! On a side note, I am seeing some ringing on the X and Y axis (see pic). I may have loosened the roller too much (or I’m printing too fast at 50mm/s). No biggie. The ringing I can fix. Now that the issue is fixed, I am planning on reprinting everyth…
-
The fix is confirmed. I took the bracket off of my printer and figured out how to tighten and loosen the rollers. I can see how I made my mistake. I didn’t understand how to properly tighten the rollers. There is only one adjustment screw that needs to be adjusted. I have attached a picture for clar…
-
jtkirk Wow!!! Great info. I have to admit, the first thing I did when I got the printer was to tighten all the rollers. It was recommended by several YouTube videos. I may have caused this issue. Ugh! The post you found makes perfect sense. Since I tightened the rollers, I bet the side opposite the…
-
I should have added that when I print at 0.2mm, I see no blobbing and the bottom layers are perfect. When I print at .15mm I start to see traces of the blobbing. The higher the resolution the worse it gets. I also forgot to mention, if the part is 100% infill, the blobbing is very bad. If the part …
-
I believe you are right about the over extrusion at the lower layers of the print. I believe the software is programed to do this by design to help with adhesion. Unfortunately, this causes a side affect when printing at high resolution on the CR-10. With that said, I don’t think the answer to the p…
-
Billr, Sorry for the delay, but I found that my Z axis stepper motor is missing steps. It is missing steps during a z-hop causing me to lose entire layers randomly throughout a print. I am waiting for a replacement and it should be here today or tomorrow. I figured I should wait before proceeding s…
-
Thanks for responding. 1. I have joined and been approved for the Facebook cr-10 group. Should I post this question there instead? I am thinking it might be a better place. 2. Printing with Hatchbox PLA (Blue and Black) 3. I have tried extruder temps 195, 200 and 205 with same result. I have trie…
-
Hello all, The fact that I am here means I am at my wits end. I cannot figure this out for the life of me. I am in need of your help. I received my first 3d printer about a week ago. It’s a Creality CR-10. After I figured out how to use it, I was getting really good prints but I always had this ri…
