-
I have an earlier model Fabtotum from the Indiegogo campaign that I have been using since May 2015. Firmware updates over the past several months have been causing problems. Before that I didn’t have any issues except for a defective power supply to Totumduino cable and the hot end heater element bu…
-
Very nice, beautiful work.
-
The only problem I have with leaving the spool in the machine is that the filament will start to absorb water vapor. The print quality starts degrading after about 3 days depending on the humidity. If you have your spool inside an airtight box with a desiccant this isn’t a problem. I keep some scra…
-
Great test objects. I have a lot of work to do as my Marvin test prints don’t look that well. The new natural PLA filament I have isn’t performing near as good as the black PLA. 1.75mm PLA: black or natural Layer Height: 0.2mm black, 0.15mm natural Nozzle/Bed Temps: 195/65C Infill: Black- 60% rect…
