print problems

3D Printers

Jul 21, '16

I found out what the problem is, the tape was peeling up itself not the glue. I think it is the heat from the PLA itself was causing the tape to peel.

print problems

3D Printers

Jul 21, '16

Okay should I keep the front open and have a fan blowing on it?

print problems

3D Printers

Jul 20, '16

It is PLA and my printer does not have active cooling or a heated bed, I print on Duck painters tape.

print problems

3D Printers

Jul 20, '16

PLA, Da Vinci JR. 1.0, Elmers X-treeme school glue stick, Duck General purpose painters tape. But as the piece itself is actualy printing the base does not appear to be bent up.

raft problems

3D Printers

Jul 18, '16

This is my third time typing this due to internet problems so I am going to make it short. The glue worked perfectly for the first 5ish prints, but every recent print the base of the thing has been bent up in a rounded cone shape. I am adding plenty of glue and as far as I can see the piece is not b…

raft problems

3D Printers

Jul 11, '16

This worked perfectly, thank you so much. You just saved me tons of time and PLA, I can’t thank you enough. -Perry

raft problems

3D Printers

Jul 10, '16

Any specific type of glue or just the average school paper glue?

raft problems

3D Printers

Jul 9, '16

So I place tape on the bed and put glue on the top of the tape

raft problems

3D Printers

Jul 9, '16

I can not customise the rafting.

alternate fillaments

3D Printers

Jun 24, '16

Thank you I was looking and it will save me quite a bit of money doing it this way.