-
USB stick.
-
Well, recognise is perhaps the wrong word, but under settings you can select the printer.
-
In case you didn’t see my mail, I’ve printed your model on an UM3 using Cura 2.4 and it worked out just fine. So, nothing wrong with the file. I also tried it without support to see how the printer would react. After the skirt, as expected, it simply produced a mess of PLA.
-
Mail it to (mail address removed)
-
I agree, and that’s why I proposed to do a test print (or at least start one). I’ve been working with Cura for over three years and I’ve learnt that if it recognises your printer, it pretty much knows what can be printed and what not. It wouldn’t even start with the skirt if it’s not compatible. So,…
-
Well, it might not be the best help you can get, but if you send me the model I will try to print it (at least start) and see whether it goes beyond the skirt. At least that will tell you whether it’s a problem with the model file or the printer settings…or an incompatibility between both. I’m using…
-
Hi, Thanks for the link. I had a look at it and it certainly is a good starting point, but personally I can’t translate this into a 3D model. Lack of skills. I hope somebody will pick up this information.
-
I’ve printed about 25 Fairphone cases so far. Most of them for customers, but also some to experiment with the settings of the printer. The major problem I encountered so far is that customers have problems fitting the phone into the case. On it’s own, that is really a minor issue that can easily b…
