-
I think I did. The steeper motor is running. Any other way to check?
-
I can push it manually, then it stops. I just took everything apart, did not brush off the drive gear as it looked ok, soaked extruders. When I put it back together, loaded the filament, and one small strand came out and stopped! If the gear that pushes the filament up against the drive gear isn’t …
-
I am using Flashforge’s PLA filament. The extruder is set at 220.
-
I did try heating the head to 220 and nothing came out. It does seem to be taking the filament in, but nothing comes out. Weird thing too, I haven’t used the right extruder in months. It was cleaned and not used. It is doing the same thing! Does look like I am taking the thing apart!
-
Yes I did. Probably did clog it then!
-
I will try that next time. I have learned a lot of stuff about this!
-
No, nothing comes out. I checked the temp and extrusion rate, all seem ok. I guess I am taking the thing apart and clearing the clog! Funny thing, it is a dual extruder and the right extruder was clean and had not been used in months. Not sure why it is not working.
