-
I think I did. The steeper motor is running. Any other way to check?
-
I can push it manually, then it stops. I just took everything apart, did not brush off the drive gear as it looked ok, soaked extruders. When I put it back together, loaded the filament, and one small strand came out and stopped! If the gear that pushes the filament up against the drive gear isn’t …
-
I am using Flashforge’s PLA filament. The extruder is set at 220.
-
Cleaned out both extruders. Put everything back together, checked settings, leveled the plate, and the printer is doing the exact same thing! It is acting like it is printing, but no filament is coming out. Any ideas?
-
I did try heating the head to 220 and nothing came out. It does seem to be taking the filament in, but nothing comes out. Weird thing too, I haven’t used the right extruder in months. It was cleaned and not used. It is doing the same thing! Does look like I am taking the thing apart!
-
Yes I did. Probably did clog it then!
-
I will try that next time. I have learned a lot of stuff about this!
-
No, nothing comes out. I checked the temp and extrusion rate, all seem ok. I guess I am taking the thing apart and clearing the clog! Funny thing, it is a dual extruder and the right extruder was clean and had not been used in months. Not sure why it is not working.
-
Everything was fine until I decided to change filament, including all prints. Just wanted a change of color! Now, neither extruder will seem to load. Same brand of PLA filament from Flashforge. Acts like it wants to work, preheats, extruders heat up, leveled, but nothing happens. Anyone else experie…
