PLA won’t stick!

3D Printers

Dec 31, '17

Your nozzle isn’t close enough to bed you want a little bit of a mush on the first layer (with pla)

Anet A8 Extruder issues

3D Printers

Dec 18, '17

Put s nut on the inside threaded all the way on the screw then the spring use the nut to increase tension [image_209.jpg]

Anet A8 stringing issue

3D Printers

Dec 18, '17

Turn your heat down a notch or two

3-way switch wiring for Anet A8

3D Printers

Oct 19, '17

A low voltage reply would be a safer way like he said mains on the frame is not best idea

3-way switch wiring for Anet A8

3D Printers

Oct 19, '17

Ok 1st off it’s not a 3way switch you want ( a 3way is used to control a light from 2 different locations your going to want single pole style switches. And they will be wire in series with each other so if you turn either one to off it’s breaking the hot wire. The white (or neutral) should be conti…

Anet A8 bad prints

3D Printers

Jul 13, '17

Watch video make sure you bolt it down level the x then level the bed

MOSFET isn't switching on heated bed

3D Printers

Mar 24, '17

Try switching the control wires from the motherboard to the mosfet

cabinet enclosure?

3D Printers

Jan 13, '17

I have mine in my garage dusty I smoke I enclosed mine but only because I plan on printing ABS so if you plan on printing any material that requires you bed to be hot an enclosure is needed only thing is make it little harder to get at things [01ea42b33447e8c8f3ab3751aa107a2cf1fcf92a6d.jpg]

Problem with objects slipping

3D Printers

Jan 11, '17

do you have any pics of your 1st layer it all starts there if your nozzle height is not set right or your bed not level nothing else will go right post a pic or two let see what ya got