-
65mm/s for me - it’s worth noting that quality issues at higher speeds might only surface under certain circumstances, e.g. when printing something tall and thin. The bed moving in the Y axis is one reason it’s not great for high speeds.
-
This is a very common problem. It isn’t due to warped glass, it relates to two things when your printer is probing the bed: 1) probing the centre of the bed causes the glass to bend giving a lower-than-it-should-be reading 2) when probing the left-hand side the x-carriage pivots on its rods only t…
-
The glue holding my bed magnets in place gave up a long time ago (since purchase in fact). This causes some bed wobble which I think leads to some inaccuracy during bed levelling. I recently bought some table cloth clips which are thin enough to slip inside the gap during y travel and provide good e…
-
I’ve done a lot of printing with Bamboofill from Colorfabb on my R1. It has a really nice finish to it, nicer than any plastics I’ve used. On the R1 it prints very well without modification. I’ve printed with both 0.4 and 0.6mm nozzles and had jams with both though the 0.6mm does present less of a …
