-
One thing that comes to mind is the nozzle height may need to be re-adjusted, especially if the printer was shipped to you and jostled around. Maybe this youtube video could help: https://m.youtube.com/watch?v=1pAPA0mImhI
-
I’ve been using a custom-cut tempered glass bed. Unfortunately all I could find in tempered glass was 1/8" thick, which meant I also had to replace the springs on the bed to shorter ones, so that the nozzle head wouldn’t hit. I’d say the whole process took less than half an hour (toughest part was r…
-
Can you upload any pictures of the issue? I haven’t experienced this before.
-
Printing skirts will definitely help with this, I also always print at least two. Even if the nozzle isn’t clogged, it can take a few seconds for the filament to get going. Extruding 10cm of filament before the print starts can help too.
