Skip to main content
Skip to profile content
-
Well I wish I had come to that conclusion. Always go back to basics, I ignored the fan went straigth for the electronics. I always reduce fan speed during warmup to about 25% on my Deltabot , then print with it around 60%
-
The heating speed is very influenced by how the small in front of the nozzles are directed. In your case it cools more tho the left than right.
-
How are they wired? By that I mean are they on the same set of wires? If yes then the one to get current first will heat up faster. Why resistance in the wire itself, run a new second set, make sure your power supply is up to the job and as always check all of your connections.
