Skip to main content
Skip to profile content
-
Can u try to pull out the filament manually? Just heat thé extension a bit more en disconnect thé guide tube on both ENDS and try to pull it out?
-
What is the temperature in thé status screen while unloading thé filament ?
-
Dies your pc go in sleepmodus? Or mabey because the screensavers jumps in… I disabeld all of these options and did not have any problems with it. But i do prefere sd card.
-
So i have a vertex K8400 with 2 nozzels my second nozzel heats up faster than the first is this normal because that one is older?
-
Dind’t know this is a thing :p!
-
The devoloper told me not to print ninjaflex until they tested is. Normaly for ninjaflex you need the feed motor ontop of the extruder. That’s what he told me on a makersfair…
