-
I printed and installed one similar to this. It works great! I did that once and never looked back.
-
I had this exact issue with simplify 3d! It happens after you use the dual-extruder wizard for some reason. All you have to do is make sure that the correct extruder is selected on each tab of the settings. Up top select either left or right extruder, then on the first tab make sure you select the m…
-
The only times I had issues with PLA not sticking to the blue plate (which is made of PET I think) was when 1. it was totally worn out, after I did TONS of ABS prints. Removing those prints over and over again wore down the structure of the blue material and finally it was smooth and shiny instead o…
-
I have printed woodfill from Microcenter successfully with regular old PLA settings. I didn’t change the speed setting one bit. Just turned off the heated bed, extruder temp was 210C and used a fan to cool the PLA as it was extruded. I have a FF Creator Pro and use Simplify3D (worth every penny). Yo…
