-
Again thanks for the responses! I looked at removing the magnets from the bed, but the black coloring for the glass is on the back so it is very easy to scratch and I would need to get all the old glue off and make sure it is smooth. So I am going to contact Robo3D tomorrow and ask them to replace …
-
Posted the same message on Thingverse and it appears the magnets were not supposed to be attached to the bed. I received an additional set of magnets I assumed were for the end blocks but it appears the intent was for me to glue them on. I guess I was accidentally shipped a print bed with them insta…
-
Has anyone had to replace the print bed on a R1? I recently dropped something on to the bed and pretty much shattered it. I ordered a replacement from Robo3D, but when I went to install it the magnets were glued on to it backwards or flipped from the original bed. In other words I cannot install th…
-
I love hatchbox, I have used multiple colors of their PLA in my M3D and had great results. You will need to adjust the temperature to 210 when using it vs 200 for the M3D filament.
