nEW HEATED BED

No category

Apr 28, '17

I have a monoprice select v2 and I am looking for a new heated bed for it. anyone have any links to one. I have got one off ebay and both times it arrived bent. on the ends. thanks krank

extruder steps tuning problem

No category

Mar 25, '17

I have the monoprice IIIp printer and have been having good luck with it. I have upgraded to the model 4 extruder gear that has the finer teeth and when I try to adjust the steps It will not get it down to 100mm. When I first started it was way off at 81mm when I tried to get 100mm. So I did the mat…

Monoprice IIIO mosfet upgrade

3D Printers

Feb 6, '17

Never mind.I just reread post and figured out my mistake.

Monoprice IIIO mosfet upgrade

3D Printers

Feb 5, '17

I just received my mosfet that I bought from amazon via the link in the wiki article on these printers. Mine doesn’t have the conector for the hb controller like the one used in the mod pics. IT hasd a green connector marked + bed -, grd d8. I am guessing I ude the one marked bed but I cant tell whi…

new to 3d printing. Quick questions.

3D Printers

Jan 30, '17

so I cancelled the order from wanhao as I am not a very patient person and ordered the Mono I3 from amazon. Saved me some money and a little sanity with my lack of patients. Thanks for the info on the long delays that would have killed me and possibly a few others . lol

new to 3d printing. Quick questions.

3D Printers

Jan 30, '17

Thanks for the tip on the steppers. I will check that once it arrives. krank

new to 3d printing. Quick questions.

3D Printers

Jan 30, '17

I just pulled the trigger on the Wanhao I3 from wanhaousa. Thanks for the help. I am sure you will be hearing from me in the future. I end up going with this one just because of all of the online support for it. I am new to all this so I will need all the support I can get. thanks again Krank

new to 3d printing. Quick questions.

3D Printers

Jan 30, '17

Where would be a good place to purchase the Wanhao from? Wanhaousa? I see I can order mono from Amazon. I have prime so that would help. Decisions decision.

new to 3d printing. Quick questions.

3D Printers

Jan 30, '17

Thanks everyone for the responses. I have been playing with Fushion 360 and so far I like it. Is there a big difference between monoprice and Wanhao? From what I could find online they seem to be the exact same machine. Is it worth it to save the money and go with the Monoprice version? If I go with…

new to 3d printing. Quick questions.

3D Printers

Jan 27, '17

I am looking at diving into the 3d printing world. I have been looking at the Wanhao 3I plus printer. I also am looking at the Fushion 360 software and also Matter hackers program for the slicer. The question I have is that the only two programs I would need to design and then print a design? I went…