-
Thanks so much for all the insight, if / when I resolve the issue I will be sure to update the thread here. Gonna take a stab at it in a week or two…
-
Hi all, My Flashforge Creator Pro is displaying inaccurate temperatures for the right extruder (it reads 205 or 207 when the extruder is at room temperature.) Weirdly, unplugging the thermocouple from the bottom where it connects to the logic board does not disrupt this reading (whereas unplugging …
-
Wanted to reactivate this thread, as I’m still troubleshooting my printer with no answers. Trying not to replace an entire extruder assembly / motherboard if I don’t have to. Has anyone experienced faulty thermocouples that, rather than showing an “error” or N/A on the display, just display wildly …
-
Hi all, My Flashforge Creator Pro started jamming up on me recently during longer prints. I went through several cycles of opening up the motor / extruder, cleaning the assembly, reassembling, and then having the same problem. Filament would extrude fine for a while, and then just seem to clog up f…
-
Not true… I have a creator pro myself and have been printing with Ninjaflex a fair amount. Also used Semiflex, Ninjaflex Cheetah, and Sainsmart flexible filament. The Ninjaflex requires a little extra care when loading (push down on the spring with your finger and feed it in manually until the gear …
-
Hi Hende, try a heated bed of at least 50C to start, with Kapton tape. Others have posted about this, so search the talk section for other recommendations as well (especially involving bed adhesion.) Cheers, -Kent
-
Thanks for all the feedback, everyone. I am printing with PLA for the time being. Will try some of the post print techniques mentioned to correct the warp. Going forward, a 70C platform seems to correct the warping much better than 50C. But apparently both of my thermocouple sensors just busted… so …
-
Thanks, guys. Adhesion is not the problem (the warping will pull the blue tape that’s on the bed up off the bed, though…) though I will get a glass bed soon most likely. I’ve upped my bed temperature to 70C and that seems to improve the prints a bit. Might try the heat gun technique… Thanks!
-
Hey everyone, printing on my new Flashforge Creator Pro and getting a little bit of warping with large, flat prints even with a heated bed (50 C.) I was wondering if anyone has tried to correct the warping of a part after the print is finished? Like, maybe turn on just the bed with preheat up to 90…
-
Right on. I miss AA. I’ve got a lot of experience with my form1+ but am just diving into the Flashforge, which I bought last week. I’m hoping to one day understand purge walls as well as you to get such nice dual extrusion prints!
-
Go, Blue!
