-
Hi all. Looking for a Photoshop guru to explain what I’m doing wrong here. I’m trying to create the base for a box I’m designing. I’ve got 2 pentagons, one inside the other and when I render the print, it cuts the base off of the smaller pentagon leaving it floating and very fragile when I print. Is…
-
I solved my problem. The printer came with a second adhesive buildtak pad. I applied the new one and I haven’t had a problem since. Wondering if those pads have some sort of finish applied that eventually wears off or if I needed to rub it down with alcohol or something.
-
Both fans are functioning normally. Back to the drawing board…
-
The fan is an option that I hadn’t thought of. I’ll check that out.
-
hi all. I have a Monoprice Maker i3 (Wanhao Duplicator) that has been printing beautifully for the past month. Out of the box all I really did was level the bed and I was off and running. Now all of the sudden, I can’t complete a single print without the corners or edges warping so bad that eventual…
-
Yeah I’m leaning more and more towards buying something nicer. Not sure how I can return this junk though because they don’t reply to any of my messages. I’ve tried to get support in 5 different ways and haven’t gotten a single reply. I checked the Better Business Bureau website and they have 40 som…
-
Yeah I was skeptical and even had decided to return it until I checked out their forum and saw all of the great prints that people were getting. That renewed my motivation to get this thing working properly. Unfortunately their support is non existent. Can you tell me what filament you use with your…
-
Thanks for the advice. I’m using ABS for my first roll, but per your experience,will switch to PLA when this roll runs out. I read that different brands and even different colors work better at different temps… can you recommend one that you have experience with that works well with the stock M3D se…
-
Thanks for the honest feedback Cristian. You’re correct in your assumption that I was reeled in by the low price. I’m a graphic artist and was honestly expecting that the learning curve would be with learning to manipulate the 3D files within my software, not simply getting the printer to print clea…
-
Hello all. I recently purchased an M3D and I could really use some help getting everything calibrated correctly since nothing I’ve attempted to print has come out with decent quality. Right now I’m trying to figure out how to adjust the temperature since I’m thinking its overheating the filament. I …
