We are 3D Printing Company base in Medan, North Sumatera, Indonesia. We provide 3D Printing services (FDM) with variety of filaments : PLA,ABS,HIPS,WOOD,FLEXIBLE,CONDUCTIVE, LUMINOUS,NYLON. Our variant of 3D Printers ( Wanhao 4X, Robo3D, Alpha, Appolo and Poseidon ) is ready to be at your services.
-
Hello, I’m using simplify3D to run my Wanhao D4X, 4S, and I3 and . It works perfectly. Beside it allows you to save your model into .x3g, Simplify3D does offer many others benefits. You might want to check it out on their website.
-
Hello Alec_Henry I strongly recommend WH Duplicator D6. Wanhao 5S has bigger build volume but its only limited to 3mm filament which is a little difficult to buy (in Indonesia, not sure at your country) as most printer use 1.75mm filaments which is widely use and available. WH D6 has max 20microns p…
-
Well, if you are planning to print it in one whole piece, then you can export to.stl at once (whole 3d model). But if your model has several colors or to avoid supports and overhang then you might want to export your model to .STL part by part and upload those .STLs to your slicing software to print…
-
Hello Will, congratulation and I understand your excitement. I have been using wanhao duplicator 4X for almost 2 years now and very satisfied with it and definitely worth the price. So I believe you will have the same experience with Wanhao I3. Good luck and can’t wait to hear from you on your print…
-
Hello GillesM, am not sure if you have already found what you’re looking for. We provide variety of filaments and our office is located Medan, Surabaya and Jakarta. Drop me a message if you need any supply.
