Skip to main content
Skip to profile content
-
I had the same issue and found adding a bit of lubricant to the tip of a piece of filament before loading was helpful. RE:
-
I would advise looking at the Simplify3D support document. I’ve found it quite helpful in solving common issues. Print Quality Guide | Simplify3D Software YMMV.
-
I too am new to this community. Mike, we’re located about 7 miles apart. I’d love to see a Prusa in action *wink wink* . My weapon of choice is the Replicator 2. I can do some rudimentary work in solidworks. My thingiverse profile has some replicator 2 improvements (http://www.thingiverse.com/funks…
