-
This can simply be prevented I found by the following method PLA run about 215, bed 20 (basically cold) cooling on pla is essential as well. bed prep either masking tape, blue with some elmers extreme gluestick lightly applied or use buildtak, or double sided kapton tape. Also try to run your fir…
-
aveDyou can fist look at the motherboard perhaps there are heaps of solutions that will give you what you want ie chitu or smoothie board, also loom at the software, ie ones that have bed leveling included ie mattercontrol, having said all that we have made ourselves machines 1000x1000x1500 for abou…
-
Personally I don’t use the perf board very often, you can try to use masking tape on the perf board and for abs coat the masking tape with glue stick, that works well for me, I then only use the perf board for nylon or wood filaments ( high shrink materials) you can also use buildtak as well it’s a …
-
I have been asked to help share some info on getting the most out of the Mankati 3D Printer. Firstly we have several machines here at DNK Systems and use them all for different reasons. We consider the mankati as a great workhorse machine that is its not spectacular in any particular facet however i…
-
Hi Gabriella3d The 80micron print wasn’t the Marvin it the other image labelled 80micron print (Marvin was done on our dnk enhanced machine apologies for the confusion) however I found that it was more the process than the machine so these would be the things that I feel made the difference for a f…
-
You can go to my hub there is an 80 micron print there done on the mankati. https://www.3dhubs.com/melbourne/hubs/dnksystems
-
The glass type is borosilicate it’s flat and designed for heat applications. Just design it up and get it made. Its basically a square plate with 4 holes so they aren’t that expensive, or use aluminium that will do the same trick as well. The heater is just stuck on so you can carefully peel it off …
-
We found and our customers very similar issues, many replace the bed with a new thicker glass or aluminium, also you can mod the feeders to help increase the flow into the nozzles with less feeder clicking. We also sell ours with a modified head cooling system, it has a light which helps with levell…
