Spiral Flower Pot!
-
Cool ! I need help with finding PETG material, I saw some listings on Amazon but I am not 100% sure. Can you recommend some good sources for filaments?
-
High Five! Nice to connect and chat soon
-
For printer management I would suggest using 3dprinteros, we used 8 ultimaker with number of students collaborating and using the 3d printers. The whole interface is very institutional friendly setup and would prefect in your case. Has ability to slice in cloud, give prints, monitor them etc and als…
-
If you are in the NYC area i can perform a full scan for $50. It would not take more than an hour. The print would be base on the size. I can go up to 8" on PLA. Something that big would probably be around $60-80. Total is Less than $200. From the day you come to take the scan it will be 4 or 5 days…
-
Must be the marketing cycles! I was receiving more orders even when I had lots of pending orders and other pay outs, it might be the case that new hubs are promoted a little extra to give everyone a fair chance. I think 3d hubs should allow hub to hub collaboration, in this way there can be a group…
-
Nope I don’t have any. Are you facing similar issue?
-
Thanks Dom, You are right but I was just surprised with no incoming orders. Anyways I have applied for address verification and haven’t got the mail yet so is it possible that my hub is not listed till its completed?
