-
Hello, So does the printer display anything on the screen and can your print for an sd card or if not by computer? Conor
-
hello, are there any more detail for the Newcastle day thanks
-
Is there a extrusion multiplier option in cura as it could just be the gcode not pushing enough plastic. I use s3d and have had gaps which was fixed by increasing the extrusion multiplier
-
https://www.simplify3d.com/support/print-quality-troubleshooting/
-
It may also be a slightly clogged extruder
-
It could be the firmware I had this issue, but i got them to send me a new board as my machine was still under warranty. If you are trying to contact they through the ctc3d website, they are terrible with communications.
-
I use simplify 3d and i is a lot better than mb’s software
-
I have the same issue with the LE, it says to check the wires. However I will need to replace the temperature sensor once we find out what type it is.
-
I completed this survey weeks ago, and I have yet to receive a badge for my hub.
-
what is the layer heigh
