3D Systems Print Plate Cleaning Tool Interest

3D Printing

Oct 18, '18

Good idea. I’m just getting started with the 3DS Projet 6000 after running a Stratasys Objet500 for a year. It does seem unnecessarily long to clean the plate. The guy training me uses an exacto knife into each hole. Gotta be a faster way.

Objet500 sprays crap all over

No category

Oct 10, '18

It was a bad board. Since they replaced it it’s all good.

Objet Print problem

3D Printing

Oct 10, '18

We had a “Z Start” setting that was too high. It put too much material on the part and it’s wouldn’t harden on a pass. It was really noticeable on thin wall. Plus our roller waste tray would get full and clog. Since it was adjusted the whole machine does a better job.

Objet Print problem

3D Printing

Jun 8, '17

Check the UV lamps. I suspect they’re out of calibration.