FlashForge Dreamer: PVA Problem & Build Plate Jerking

3D Printers

Apr 14, '16

Ok, been a while, I know, and I fixed the build plate issue. It was getting caught in the side of the roll of filament. Kind of a dumb mistake. I lowered the temperature on the PVA extruder, but… it’s clogged, probably from when it was at 200 degrees Celcius. So, I have to unclog that basically… I…

FlashForge Dreamer: PVA Problem & Build Plate Jerking

3D Printers

Apr 4, '16

Thanks a lot, I’m going to try to find a way to fix the axis, or find something about some of the internal wiring.

dual print issue with PLA and PVA

Materials

Apr 4, '16

I have a Dreamer too, and I’ve been experiencing the same problem. Only that my build plate goes berserk every time I cancel a print. It literally jerks up and down for 3 seconds before stopping, and I have to level it again. very annoying. must find a solution…